Angelo Po 0N0TPG Bedienungshandbuch Seite 149

SERVICING
To carry out this operation, proceed as follows.
)
Turn off the gas supply tap.
Pull off the knob (A).
)
Undo the screws (C) and remove the control
)
panel (B).
Undo the screw (D) of the pressure connec-
)
tion.
Connect the pressure gauge (E) to the pres-
)
sure test point (F).
)
Turn the gas supply tap back on.
)
Light the burner and turn the knob to the full
fl ame setting, then check that the pressure
reading complies with the values in the table
(see back of manual).
)
Turn off the burner, disconnect the pressure
gauge and restore the initial conditions after
completing the operation.
HANDLING AND INSTALLATION
INSTRUCTIONS AND WARNINGS FOR HANDLING AND INSTALLATION
: Read the following sections
NOTE
carefully before performing any handling
and installation operations; read the
following sections of the "User instruction
manual":
– Hazards and safety provisions during trans-
port.
– Hazards and safety provisions during assem-
bly.
– Hazards and safety provisions during installa-
tion, commissioning, adjustments and part re-
placement
WARNING : All handling and instal-
lation operations shall be carried out in ac-
cordance with current legislation on health
and safety at work.
3320091_inst_GB
CHECKING GAS PRESSURE
If necessary, the person authorised to car-
ry out these operations should organise a
"safety plan" to protect the people directly
involved.
tions (water, electricity, and gas) must be set
up exclusively by suitably qualifi ed staff , in
accordance with local requirements.
C
A
C
B
:The required connec-
WARNING
ENGLISH
F
E
D
7