Angelo Po 0N0TPG Bedienungshandbuch Seite 32

ENGLISH
HAZARDS AND SAFETY PROVISIONS DURING ASSEMBLY
When assembling the appliance, watch out for the following hazards and provide for the coun-
termeasures indicated below:
► Source of hazard: Handling of heavy loads
Where or in which situations
Hazard
does the hazard occur?
Risk of in- • When the appliance
jury due to body
overload
HAZARDS AND SAFETY PROVISIONS DURING INSTALLATION AND
COMMISSIONING, ADJUSTMENTS AND PART REPLACEMENT
During appliance installation, commissioning, adjustment and part replacement procedures,
watch out for the following hazards and provide for the countermeasures indicated below:
► Source of hazard: Appliance mechanics
Hazard
Risk of crushing
parts of the body in
case of tip-over or
fall of the appliance
Risk of cutting due
to sharp edges
Risk of crushing
parts of the body
in case of fall of the
appliance
6
moves
Where or in which situations
does the hazard occur?
When the appliance is
lifted
When handling sheet-
metal parts
In case of uneven or
sloped fl oors
Countermeasures
• Use a suitable lifting de-
vice to place the appliance
on the work bench, on the
base
• Adjust the position only if a
suitable number of people
is available, otherwise ob-
serve the limit values for
lifting and transport
• Comply with the applicable
laws on accident preven-
tion for the installation
place
• Wear personal protective
equipment
Countermeasures
• Pay attention to the centre
of gravity
• Avoid collisions
• Pay special care during
this activity
• Wear personal protective
equipment in accordance
with safety regulations
• Comply with the correct in-
stallation requirements as
per section "Installing the
appliance" on page 10 of
the installation manual.
SAFETY
Safety device
• Protective
gloves
• Protective
shoes
• Safety hel-
met (e.g. for
suspended
loads, overhead
operations...)
Safety device
None
None
None
3320091_ut_GB