Gas Connection; Connection Of Fume Exhaust Vent - Angelo Po 0N0TPG Bedienungshandbuch

HANDLING AND INSTALLATION
: The connection opera-
WARNING
tions must be carried out by qualifi ed per-
sonnel with an acknowledged experience in
the specifi c fi eld, in accordance with the ap-
plicable legislation in the country where the
appliance is installed.
The connection must be carried out with due
care and must comply with all applicable
regulatory and legal requirements. When
the connection is complete and before the
appliance is put into operation, a general
check for any gas leaks is required.
To make the connection, connect the mains
line to the appliance's connection pipe, fi tting a
shut-off tape (A) , to allow the gas supply to be
cut off when necessary.
: The tap (A), which is not
WARNING
supplied with the appliance, should be installed
in an easily accessible position and its status (on
or off ) must be identifi able at a glance.
IMPORTANT
must comply with the national requirements
in force and must be periodically checked
and replaced if necessary.
: Make the connection in
WARNING
compliance with the relevant legal require-
ments, using appropriate and recommen-
ded materials.
) Position the appliance
underneath the hood (A)
(see diagram).
: The gas
WARNING
supply tap (A) must open
automatically when the fan
of the extraction system is
switched on.
3320091_inst_GB

GAS CONNECTION

: The gas supply pipe

CONNECTION OF FUME EXHAUST VENT

A
A
: Do not connect the appli-
HAZARD
ance to the gas distribution system contain-
ing carbon monoxide or other toxic compo-
nents.
: The gas feed pipe must
WARNING
not be longer than 2 metres.
Connecting to a fan extractor hood
To carry out this operation, proceed as follows.
A
ENGLISH
11