Vicon MH 180S Betriebsanleitung Seite 85

Note: Parts/assys listed below can be standard equipment in your area: contact you dealer.
Option
1. MH 180S:
swivel hitch frame:
2. Lamp support set:
3. Long remote control:
4. MH 180S: skid set:
5. MH 180SU:
multiple selector valve set:
6. MH 180SU:Trailer hitch, upper
(56, fig. 11):
MH 180SU:Trailer hitch
extension, lower:
7. Change gear set:
8. Gathering comb set (fig. 31):
9. Stiffener set (figs 36 and 36A):
10. Stem lifter, outer (54, fig. 32):
Stem lifter, inner (55):
G9905NT3
XV. OPTIONAL EQUIPMENT
part no.
This swivel hitch frame enables chopping both at the
TP00629
right and at the left with wide tractors (250 cm). This
enables chopping a plot from one side. The tractor
keeps about 20 cm (8 in) distance to the standig
crop. Problem caused by unfavorable univ. joint
angles are avoided. It provides:
A: Parallel side shift of max. 30 cm (11-13/16
B: Angled side shift of 38 cm (15 in) both to the
TP00372
Provides a simple attachment for lighting.
ND9726
Required for front mounting (also for 'TP00629')
TP00644
Improves ground adaptation on tractors with
suspended axles and/or on front mounted chopping.
Using this set a tractor with only one double acting
TP00524
valve can be used. Connect as follows (fig. 34):
A and B:
C and D:
TP00501 For trailers with high draw bar.
TP00543
For trailers.
NT0032
The chopping length can be set to 6 mm (or 15 mm
if used together with option 14; see IX.5.A.).
NT0026
Ensures regular feed of lodged and / or slippery
maize.
NT0041
Replaces a removed chopping knife for increasing
the chopping length to 10 mm (or to 15 mm if the
change gears have been used) (see IX.5.B.).
TP00208
Separate long, lodged or bend over crop (include
guide extensions).
TP00209
table 3
EN18
Use
in), both to the right and to the left (fig. 38).
right and to the left, in its utmost outer
position the chopper has a 5
(fig. 39).
hoses to supporting wheel cyclinder,
hoses from chute rotation/lateral
movement to tractor in fig. 2.
o
angled position