Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.4
Electrical connection
DANGER - Risk of electric shock in the
absence of grounding, a faulty ground
connection or a faulty power connector.
Faulty phase, neutral conductor or grounding
cable connections may cause electric shock,
cardiac arrest and death!
¶
Work on the electrical installation or
electrical equipment may only be carried
out by a qualified electrician or by trained
personnel under the direction and
supervision of a qualified electrician.
¶
Also minor work on the electrical
equipment may only be carried out by
qualified and trained personnel.
¶
Only connect to the power supply if the
supply voltage available corresponds to
the rated voltage specified on the rating
plate.
¶
Ensure proper grounding before making
the electrical connection.
!
The device must be connected to a standard
electrical system that is equipped with a residual-
current-operated circuit breaker with a wire cross-
section of at least 3 mm conforming to European
standards. The customer is responsible for providing
fuse protection for the power connector.
!
A two-pole type "C" automatic circuit breaker must
be used to protect the power connection. Single-
pole automatic circuit breakers are not allowed.
!
Observe the temperature and ambient operating
conditions listed in the "Technical data" section.
!
A motor starter (or similar protective device) must
be installed to protect against short-circuits.
Version
Trip
class
110 V, 1 Ph, 50/60 Hz 10
230 V, 1 Ph, 50/60 Hz 10
400 V, 3 Ph, 50 Hz
10
Tab. 5:
General overview of motor starters
SICAM srl soc. Unip
Initial commissioning | FALCO EVO 628 S (IT) V8 | 53
Adjustable
Set value
range
17 A - 22 A
20 A
9 A – 12,5 A 10 A
2,8 A – 4 A
3,5 A
¶
Have a qualified electrician fit a country-specific 230-
V single-phase or AC connector based on the voltage
rating ordered.
i
Machine variants supporting 110 V single-phase AC
come with a connector.
Connection of three-phase connector
L2
L1
PE
L3
Fig. 23:
Color code for AC connection
Phase
Designation
L1
Phase 1
L2
Phase 2
Phase 3
L3
Protective conductor
PEPE
Tab. 6:
Color code for three-phase connection
Connection of single-phase 230-V connector
L
N
PE
Fig. 24:
Color code for single-phase connection
Phase
Designation
L
Phase 1
Neutral
N
PEPE
Protective conductor
Tab. 7:
Color table for single-phase connector
en
Cable color
Gray
Black
Brown
Green/yellow
Cable color
Brown
Blue
Green/yellow
|
2019-02-20
1 695 109 039
Werbung
