Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en
50 | FALCO EVO 628 S (IT) V8 | Initial commissioning
4. Use block and tackle of sufficient strength (see
"Technical data") to lift the FALCO EVO 628 S (IT) V8
and erect it at the intended location. Pay attention
to the minimum distances as shown in the
illustration.
Fig. 11:
Attach the straps
Warning - danger of tilting!
The center of gravity of the
FALCO EVO 628 S (IT) V8 is not in the middle.
¶
Always lift the FALCO EVO 628 S (IT) V8
slowly.
Fig. 12:
Clearances when setting up
!
For safe and ergonomic operation
of FALCO EVO 628 S (IT) V8 must
FALCO EVO 628 S (IT) V8 be set up at a minimum
distance of 500 mm to the nearest wall. When doing
|
1 695 109 039
2019-02-20
so, remember to allow for the maximum space
requirement when extending the moving parts into
operating position.
i
Rubber vibration dampers have been inserted at the
designated points to ensure low-vibration mounting
on the floor.
Fig. 13:
A Vibration dampers
5. Remove the lifting straps from the machine.
6. Fill the lubricant tank with off-the-shelf tire
mounting paste.
i
Do not use solvent-based lubricants as these could
damage the tires. Never use flammable liquids for
lubricating or positioning the tire bead.
7. Re-attach the plastic cover as shown in the illustration.
652172-14_BM
Fig. 14:
Vibration dampers
Re-attaching plastic cover
SICAM srl soc. Unip
Werbung
