Sicam FALCO EVO 628 S V8 Originalbetriebsanleitung Seite 48

en 48 | FALCO EVO 628 S (IT) V8 | Initial commissioning
4. Initial commissioning
4.1 Unpacking
1. Place the packed goods near the installation
location.
i
Use an appropriate fork lift or a pallet truck (with
a minimum load capacity of 500 kg) to move the
packed machine. Insert the forks between the
support legs of the palette and lift the packaging.
2. Remove the strap and retaining clamps from the
pallet and the packaging carton.
3. Carefully lift off the packaging.
4. Take the standard accessories and the packaging
material out of the transport crate.
i
Check if the FALCO EVO 628 S (IT) V8 and the
accessories are in proper working order and that
there are no visible signs of component damage. In
case of doubt, do not commission the device and
consult customer service.
i
Dispose of the packaging material at an appropriate
collection site.
4.2 Structure
¶
Remove the plastic cover at the base of the column.
Fig. 4: Removing the cover at the base of the column
|
1 695 109 039 2019-02-20
4.2.1 Attaching the compressed-air tank
i
The compressed-air tank is supplied only with the
machines FALCO EVO 628 S IT V8.
i
The screws for fastening the container are already
attached. Remove them for later use. If the
connecting pieces should not be pre-installed, they
are included in the scope of delivery.
1. Unpack the compressed-air tank and remove the
packaging material.
2. Use the provided screws to attach the compressed-
air tank to the holes of the structure.
2
1
Fig. 5: Attaching the compressed-air tank
3. Remove the hose and attach it to the compressed-
air container. Then secure it by means of the screw
clamp.
Fig. 6: Connecting the rubber hose
1
M8x20
2
M8
SICAM srl soc. Unip