Operation - Cameo OTOS SP6 Bedienungsanleitung

11
RECESSED GRIPS
In addition to the two transport handles on the base of the unit, there are practical recessed grips
at the top of the inner sides of the two device arms.

OPERATION

NOTES
Once the fixture is correctly connected to the mains, the display will show "Software
Update ...please wait", the software version, "Welcome to Cameo" and "...RESET"
during the start-up procedure and motor reset. After this process, the spotlight is
ready for operation and the previously activated operating mode is launched. The
main display is activated automatically if no input is made within approximately 30
seconds.
MAIN DISPLAY
The main display shows different information relevant to the various operating modes.
DMX and W-DMX operating modes
LED-Temperature
DMX-Starting Address and DMX-Mode
Stand-alone operating modes
LED-Temperature
Scene / Loop and Signal Output
ArtNet and sACN operating modes
LED-Temperature
W-DMX Status
Error Message
DMX-Mode, DMX-Address, IP-Adress, Subnet
Mask and Galaxy
Operating mode Slave
LED-Temperature
W-DMX Status
Error Message
W-DMX Status
Mode
Error Message
W-DMX Status
Mode
Error Message
15