Operation Per Unit Controller Cameo Unicon - Cameo G4 TW Bedienungsanleitung

Control via cable
(RJ45, W-DMX deactivated)
LED lights up
permanently blue
LED flashes blue
LED off
OPERATION PER UNIT CONTROLLER CAMEO UNICON (optionally available)
After you have switched on the Unit Controller UNICON (briefly press BACK to switch it on),
"Update, Please Wait" appears briefly in the display (for service purposes only) and then the main
menu. Connect the remote unit to the Gallery Light G4 TW via network cable and connect the
spotlight to the power supply.
Select the menu item RDM/Fixture and confirm the selection. Now the system searches for
connected RDM devices (Discovery) and if the G4 TW is correctly connected and switched on,
a device is found (Discovered: 1). After a short time, the G4 TW is displayed as the only unit in a
list (the first part of the displayed RDM unit shows the unit model, the second part behind "/" is
the label and can be individually adjusted in the menu item Label for easier identification). Now
confirm to enter the submenu.
14
DMX signal is present
No DMX signal
Stand-alone
operation
Control via W-DMX
™
LED flashes red with
approx.1Hz
LED flashes red quickly
LED is permanently
lit green
LED flashes green
Functions of the controls
Display
Value up

Value down

Back

✔
Confirm
Activate W-DMX
Pairing with a
transmitter cancelled
and set to pairing
readiness
Paired, DMX signal
present
Paired, no DMX signal
Encoder + BACK
↻
↺
Back