Control Menu - Cameo OTOS SP6 Bedienungsanleitung

NOTE REGARDING THE MAIN DISPLAY IN OPERATING MODES WITH EXTERNAL
CONTROL:
As soon as the control signal is interrupted, the characters in the centre of the display
begin to flash. The flashing stops when a control signal is present.
Error message: If the warning symbol (triangle with exclamation mark) appears in
the display, there is an error in one or more components of the unit. Which compo-
nents are affected can be seen in the System Info Menu under Error Info. If the
error cannot be rectified by a restart or reset, please contact an authorised service
centre.
W-DMX
™
To pair a W-DMX receiver with a W-DMX compatible transmitter, the Reset command must be
executed in the menu item WDMX under Receiver (select and confirm Reset). The receiver is
now in pairing standby and waiting for a pairing request from a transmitter. Start the pairing
by selecting Link in the menu of the transmitter and confirming; the pairing now takes place
automatically. In the same way, several receivers can be paired simultaneously or one after the
other to a transmitter (e.g. for master/slave operation). A W-DMX connection is always maintained
until the connection is disconnected by means of the Reset command in the receiver or the Unlink
command in the transmitter, regardless of whether a device has been disconnected from the
power supply in the meantime.
W-DMX STATUS
™
W-DMX
deactivated as receiver

CONTROL MENU

The control menu enables selection of the various operating modes and their setting options in
the relevant sub-menus. DMX address and DMX operating mode are set in each operating mode
across all operating modes, if relevant.
OPERATION VIA DMX CABLE
Starting from the main display, press MENU to enter the main menu. Using  and , select the
Control menu and press ENTER. Now select the DMX menu item and confirm again.
16
?
W-DMX W-DMX
as receiver
activated, activated and
not paired paired,
Transmitter
switched off
or out of
range
W-DMX W-DMX
as receiver
as receiver
activated and activated and
paired, paired,
no DMX signal
DMX signal is present
W-DMX
as transmitter
activated,