Lc-Display - Cameo OTOS SP6 Bedienungsanleitung

7 LC DISPLAY
The illuminated display shows the currently activated mode (main display), the menu items in the
main menu and sub-menus and the numerical value or status in certain menu items. If there is no
control signal to the device, the characters in the centre of the display start flashing; the flashing
stops as soon as a control signal is available (W-DMX, DMX and slave operation).
8
TOUCH-SENSITIVE CONTROLS
MENU – Press MENU to access the main menu. Press again or repeatedly to return to the main
display.
 and  – Select the menu items in the main menu (DMX address, operating mode, etc.) and in
the submenus using  and . Change value or status in a menu item, e.g. DMX address.
ENTER – Press ENTER to access the menu level to make value or status changes, and to access
one of the sub-menus. Confirm value or status changes by pressing ENTER.
Before navigating the unit menu, make sure that the control panels are dry and clean so that their
functionality is not impaired.
PRESSURE EQUALISATION ELEMENT
The pressure compensation element to prevent condensation inside the housing is located in the
rear part of the unit head. In order to ensure its proper function, the element must be protected
from contamination.
W-DMX ANTENNA
™
The antenna for control via W-DMX
ATTENTION: To ensure IP65 splash protection for the DMX and network sockets,
the special input and output sockets must be correctly sealed with the IP65 special
plugs or the rubber sealing caps must be used for sealing. When connected correct-
ly, or when sealed correctly with the rubber sealing caps, the POWER IN and POWER
OUT sockets are protected from spraying water, as in accordance with IP65.
7
is located inside the unit base.
™
8
13