Operation Via Art-Net - Cameo OTOS SP6 Bedienungsanleitung

Off
Receive On
Unlink
Send to XLR
Signal
Backup by XLR Control via XLR (DMX IN) with W-DMX signal interruption
routing
Receive only

OPERATION VIA ART-NET

Starting from the main display, press MENU to enter the main menu. Using  and , select the
Control menu and press ENTER. Now select the menu item ArtNet and confirm again.
Information on the submenu items in the ArtNet menu and the corresponding setting options can
be found in the table below (select with  and  confirm with ENTER, change value or status
with  and  confirm with ENTER).
ArtNet
DMX Address 001 - 4xx
33CH / 36CH /
DMX Mode
50CH
Universe 000–255
Universe Group 000–127
xxx.xxx.xxx.
IP Address
xxx.xxx
xxx.xxx.xxx.
Subnet Mask
xxx.xxx
On
Off
W-Transmitter
Force to pair
Unlink all
Send to XLR
Signal Routing Backup by XLR Control via XLR with ArtNet signal interruption
Receive only
18
Deactivate W-DMX reception
Activate W-DMX reception
Disconnect W-DMX connections and put them in coupling standby
Forwarding the control signal to XLR (DMX OUT)
No connection between W-DMX signal and XLR connectors
Setting the DMX start address
Selecting the DMX mode
Setting the universe
Setting the Universe Group
Setting the IP address: Set 1st block, confirm, Set 2nd block,
confirm..
Setting the subnet mask: Set 1st block, confirm, Set 2nd
block, confirm..
Activate (On) or deactivate (Off) forwarding of the DMX signal
via W-DMX.
Establish a connection with other W-DMX units (Force to
pair) or disconnect them (Unlink all).
Forwarding the control signal to XLR Out
No connection between network signal and XLR connectors