Cameo OTOS SP6 Bedienungsanleitung Seite 19

OPERATION VIA SACN
Starting from the main display, press MENU to enter the main menu. Using  and , select the
Control menu and press ENTER. Now select the menu item sACN and confirm again.
Information on the submenu items in the sACN menu and the corresponding setting options can
be found in the table below (select with  and  confirm with ENTER, change value or status
with  and  confirm with ENTER).
sACN
DMX Address 001 - 4xx
33CH / 36CH /
DMX Mode
50CH
Universe 000–255
Universe Group 000–127
xxx.xxx.xxx.xxx.
IP Address
xxx
xxx.xxx.xxx.xxx.
Subnet Mask
xxx
On
Off
W-Transmitter
Force to pair
Unlink all
Send to XLR
Signal Routing Backup by XLR Control via XLR with ArtNet signal interruption
Receive only
EDIT SCENE
Eight scenes are available (Scene 1 - 8). Set pan, tilt, gobo, pan / tilt macros etc. of each scene
individually directly on the unit with values from 000 to 255. The scenes are pre-programmed ex
works.
Setting the DMX start address
Selecting the DMX mode
Setting the universe
Setting the Universe Group
Setting the IP address: Set 1st block, confirm, Set 2nd block,
confirm..
Setting the subnet mask: Set 1st block, confirm, Set 2nd
block, confirm..
Activate (On) or deactivate (Off) forwarding of the DMX signal
via W-DMX.
Establish a connection with other W-DMX units (Force to pair)
or disconnect (Unlink all).
Forwarding the control signal to XLR Out
No connection between network signal and XLR connectors
19