Cameo OTOS SP6 Bedienungsanleitung Seite 32

6
Gobo wheel with the rotating gobos: Lift the gobo holder on the gear wheel slightly upwards
and then pull it out of the gobo wheel.
7 Gobo wheel with the fixed gobos: Turn the gobo wheel with the rotating gobos with the „Open"
opening over the desired gobo of the gobo wheel with the fixed gobos, press the gobo holder
down slightly through the opening and then pull it out of the gobo wheel.
8 The gobo can now be removed from the bracket and replaced with another one.
9
Then place the gobo bracket back into the gobo wheel, ensuring that the gobo bracket is
correctly seated in the corresponding recess. With the rotating gobos, you can check that they are
seated correctly by turning the gobo wheel; the gobo must rotate without hooking.
10 Reinstall the module in the headlamp head, secure it with the help of the two previously loo-
sened screws and reconnect the two plugs for the voltage and signal supply to the corresponding
connections.
11
Remove the old seal from the groove in the installation bay surround.
12 Thoroughly clean the groove and the contact surface of the cover. Make sure that the contact
surfaces of the seal are free from foreign objects and dirt.
13 Remove the new seal from the packaging and remove any residues of the mould release
agent.
14
Now place the seal positively into the groove. Ensure that the seal is not twisted.
32