Cameo OTOS SP6 Bedienungsanleitung Seite 31

1
Disconnect the unit from the power supply at all poles (pull out the mains plug). Lock the
headlamp head (pan and tilt lock).
2 Loosen the hexagon socket screws of the unit head cover (see markings), remove the cover
from the headlamp head, loosen the cover's safety rope and put it aside.
3 Disconnect the two connectors for the voltage and signal supply of the gobo module.
4
Now remove the two screws holding the module in the guide and pull the module out of the
headlamp head.
4
To avoid contaminating the gobos, please wear lint-free gloves.
5 Place the module on a clean and flat surface with the gobo wheels facing upwards. Turn the
desired gobo towards the front of the module.
3
4
31