Operation Per Unit Controller Cameo Unicon (Optionally Available) - Cameo G4 FC Bedienungsanleitung

Control via cable
(RJ45, W-DMX deactivated)
LED lights up perma-
nently blue
LED flashes blue
LED off

OPERATION PER UNIT CONTROLLER CAMEO UNICON (optionally available)

After you have switched on the Unit Controller UNICON (briefly press BACK to switch on), "Update,
Please Wait" (for service purposes only) appears in the display for a short time and then the main
menu. Connect the remote unit to the Gallery Light G4 FC via network cable and connect the
spotlight to the power supply.
Select the menu item RDM/Fixture and confirm the selection. Now the system searches for
connected RDM devices (Discovery) and if the G4 FC is correctly connected and switched on,
a device is found (Discovered: 1). After a short time, the G4 FC is displayed as the only unit in a
list (the first part of the displayed RDM unit shows the unit model, the second part behind "/" is
the label and can be individually adjusted in the menu item Label for easier identification). Now
confirm to enter the submenu.
All information and configuration options for the spotlight that can be called up and edited via
RDM are now displayed.
14
DMX signal is present
No DMX signal
Stand-alone oper-
ation
Control via W-DMX
™
LED flashes red with
approx.1Hz
LED flashes red quickly
LED is permanently lit
green
LED flashes green
Functions of the controls
Display
Value up

Value down

Back

✔
Confirm
Activate W-DMX
Pairing with a
transmitter cancelled
and set to pairing
readiness
Paired, DMX signal
present
Paired, no DMX signal
Encoder + BACK
↻
↺
Back