Connections, Operating And Display Elements - Cameo OTOS SP6 Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1
1
POWER IN
IP65 power input socket with rubber sealing cap. Operating voltage 100–240 V AC/50–60 Hz.
Connection via supplied power cable (when not in use, always close with rubber sealing cap).
2
POWER OUT
IP65 power output socket with rubber sealing cap. Facilitates power supply to other CAMEO
spotlights. Ensure that the total current consumption of all connected devices does not exceed
the value specified on the device in amperes (A) (when not in use, always close with the rubber
sealing cap).
3 DMX IN
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console; when not in
use, always close with the rubber sealing cap).
4 DMX OUT
Female IP65 5-pin XLR socket for sending DMX control signal (when not in use, always close with
the rubber sealing cap).
5
NET IN / OUT
RJ45 network connections for connecting to an ArtNet or sACN network and for forwarding the
control signal (always close with the rubber sealing cap when not in use). Use CAT 5e or better
cables to set up the network.
6 FUSE
IP65 fuse holder for 5 x 20mm fuses. IMPORTANT NOTE: Replace the fuse only with one of the
same type and rating. Carefully close the fuse holder again so that the IP65 tightness is still gua-
ranteed. In the event of repeated fuse failure, please contact an authorised service centre.
12
6
2
5
3 4