Checchi & Magli TOP 24 Bedienungs- Und Wartungsanleitung Seite 67

Night-time work or poor visibility conditions
Working at night or in low visibility conditions increases
the risks that derive from the use of the machine.
Transporting the work vehicle
WARNING
For work vehicle loading/unloading, use lifting
equipment with a suitable capacity for the load to be
lifted.
Use all possible caution when lifting to avoid damag-
ing the work vehicle and causing injuries to persons
involved in operations.
Strap up the unit at the lifting points envisaged by the
manufacturer.
See the strap-up points and lifting procedures in the sec-
tions titled "Lifting the work vehicle" on page 10.
Anchor the work unit to the means of transport with
ropes and secure the wheels with wedges.
UN41-0912UA
Proceed as outlined below.
1) Start the tractor and lift the work vehicle as far off the
ground as is permitted.
2) Board the means of transport, as shown in the figure,
travelling at low speed.
3) Lower the machine onto the bed of the means of
transport.
4) Off the tractor engine and engage the parking
English language
INFORMATION FOR USE
During work at night or in poor visibility conditions,
proper lighting must be provided to ensure safe work.
Units which are narrower than the maximum width al-
lowed by the Highway Code can be loaded , coupled to
the tractor, onto suitable means of transport using load-
ing ramps.
WARNING
Thoroughly clean the ramps and loading platform
before boarding the vehicle.
Position the ramps on the transport means and fix
them in a stable way to the truck bed using the fas-
tening devices (pins, screws, chain etc.).
Where the ramps meet the truck bed there is a dan-
gerous bump so move the machine very carefully
over this point.
brake.
5) Unhitch the work vehicle from the tractor.
6) Anchor the work unit to the means of transport with
ropes and secure the wheels with wedges.
7) Before transporting, affix the relative signalling signs
to any parts jutting out from the means of transport.
25
6
Use and maintenance