Optional Batteries For High Power (When Using 12 X 6 Propeller); Required Tools And Adhesives; Optional Tools And Adhesives; Building Precautions - Horizon Hobby HANGAR 9 Fun Scale PT-19 PNP Bedienungsanleitung

OPTIONAL BATTERIES FOR HIGH POWER (WHEN USING 12 X 6 PROPELLER)

# Required Part #
1 SPMX40006S30 4000mAh 6S 22.2V Smart 30C; IC5
1 SPMX50006S30 5000mAh 6S 22.2V Smart 30C; IC5

REQUIRED TOOLS AND ADHESIVES

Balancing stand
Flat-blade screwdriver
Nut driver: 1/4-inch
Phillips screwdriver: #1, #2
Square

OPTIONAL TOOLS AND ADHESIVES

Silicone Adhesive
Thin CA

BUILDING PRECAUTIONS

During assembly, we recommend resting the parts on a soft surface such as a soft towel to help prevent denting the
sheeting.

REMOVING WRINKLES

The covering of your model may develop wrinkles during shipping and will require the use of a heat gun (HAN100)
and covering glove (HAN150) or covering iron (HAN101) with a sealing iron sock (HAN141) to remove them. Use
caution while working around areas where the colors overlap to prevent separating the colors. Avoid using too much
heat, which could separate the colors. Placing a cool damp cloth on adjacent colors will also help in preventing the
separation of the colors while removing wrinkles.
EN
Description
Description
Description

CHECKING THE AILERON SERVOS

1. Pull the aileron servo leads through the holes in the top of the
wing.
2. Connect the aileron servo to the receiver. Center the aileron
stick and trim. Check that the pushrod is 90-degrees to the
servo arm. If not, either remove the servo arm and adjust, or
use the sub-trim when using a computer radio.
3. Check the aileron to make sure it is aligned with the wing.
4. If the aileron is not aligned, disconnect the clevis and thread it
in or out to correct the alignment of the aileron.
5. Once adjusted, reconnect the clevis to the aileron control
horn. Slide the silicone retainer over the forks of the clevis to
prevent it from disconnecting from the control horn
 Repeat this section for the remaining wing panel.
4