Required Adhesives; Tools Required; Removing Wrinkles; Building Precautions - Horizon Hobby HANGAR 9 Aermacchi MB-339 Bedienungsanleitung

REQUIRED ADHESIVES

15-minute epoxy
30-minute epoxy
Canopy Glue
Thin CA
Medium CA
Threadlock, low and high strength

TOOLS REQUIRED

Balancing stand
Drill and tap set, metric
Drill bit set, Imperial or Metric
Epoxy brushes
Felt-tipped pen
Hemostats
Hex wrench set, Imperial and Metric
Hobby knife with #11 blade
Hook and loop straps
Hook and loop tape
Isopropyl alcohol
Low-tack tape
Mixing sticks
Needle nose pliers
Nut driver set, Imperial and Metric
Paper towels
Pencil
Petroleum jelly
Phillips screwdriver: #1, #2
Pin vise
Ruler
Sandpaper
Scissors
Side cutters
Square
Tap handle
Tie wraps
Toothpicks
Wire stripper
EN
Description
Description

REMOVING WRINKLES

The covering of your model may develop wrinkles during shipping and will require the use of a heat gun (HAN100)
and covering glove (HAN150) or covering iron with a sealing iron sock (HAN141) to remove them. Use caution while
working around areas where the colors overlap to prevent separating the colors. Avoid using too much heat, which
could separate the colors. Placing a cool damp cloth on adjacent colors will also help in preventing the separation of
the colors while removing wrinkles.

BUILDING PRECAUTIONS

Prepare the work surface prior to beginning the build. The surface should be soft and free of any sharp objects. We
recommend resting the airframe parts on a soft towel or pit mat to prevent scratching or denting the surface of the
aircraft.

TRANSPORTATION AND STORAGE

Use the three-view drawing on page 90 to determine how much room will be required to transport and store your
model. We also recommend the use of wing and stabilizer bags to help protect these surfaces during transport and
storage. The control horns and linkages can cause damage to other surfaces even when placed in storage bags.
Always transport and store the wings and stabilizer so the linkages do not contact other panels to prevent damage.

CHECKING BLIND NUTS

When building the aircraft, you will be required to thread machine screws into blind nuts. We recommend pre-threading
the screws to make sure the blind nuts are clear of any debris. If the screws do not thread in easily, clear the threads
using the appropriate tap and tap handle.

REPLACEMENT COVERING

Your model is covered with UltraCote film in the following colors. If repairs are required, order these coverings to
®
make those repairs.
HANU870 White
HANU877 Orange
HANU873 Deep Blue
4