Connection To An Amplifier - HBM C10 Montageanleitung

Electrical connection
7.1

Connection to an amplifier

Fig. 7.1 Pin assignment in a six wire circuit
Fig. 7.2 Pin assignment for HBM cables
The output signal is positive with this pin assignment and load in the pressure
direction. If you want a negative output signal in the pressure direction, swap
pins B and C (red and white in HBM cables).
24
Device plug pin assignment
B Measurement signal (+)
D Excitation voltage (-)
C Measurement signal (-)
A Excitation voltage (+)
F Sense lead (+)
E Sense lead (-)
Cable shield, connected to the housing
Threaded connector
A04036_01_YI0_03 HBM: public
Bayonet connector
Cable assignment
wh (white)
bk (black)
rd (red)
bu (blue)
gn (green)
gy (gray)
Shield
C10