Safety Instructions - HBM C10 Montageanleitung

Safety instructions

1 Safety instructions
Intended use
Force transducers in the C10 type series are designed solely for measuring
static and dynamic compressive forces within the load limits stated in the
specifications. Any other use is not appropriate.
To ensure safe operation, it is essential to comply with the regulations in the
mounting instructions, the safety requirements listed below, and the data
specified in the technical data sheets. It is also essential to observe the
applicable legal and safety regulations for the application concerned.
Force transducers are not intended for use as safety components. Please also
refer to the "Additional safety precautions" section. Proper and safe operation
of force transducers requires proper transportation, correct storage, siting and
mounting, and careful operation.
Load-carrying capacity limits
It is essential to comply with the information in the technical data sheets when
using force transducers. The respective specified maximum loads in particular
must never be exceeded. The following are set out in the technical data sheets
and must not be exceeded:
S Limit forces
S Lateral limit forces
S Bending moments
S Breaking forces
S Permissible dynamic loads
S Temperature limits
S Electrical load limits
Please note that when several force transducers are interconnected, the load/
force distribution is not always uniform.
C10 3
A04036_01_YI0_03 HBM: public