HBM C10 Montageanleitung Seite 11

Design variants
All force transducers are available in different versions. The following options
are available:
1. Number of measuring bridges
In the standard version, the C10 comes with one measuring bridge. The
force transducer is also available with two electrically isolated measuring
bridges.
2. Sensitivity
Thanks to the high mechanical reserves of the C10, there can be a high
output signal of more than 4 mV/V. (2.5 kN, 5 kN and 10 kN versions
>2 mV/V). Should this mean overloading your amplifier, a C10 can be
adjusted to an output signal of 4 mV/V or 2 mV/V.
3. Calibration
In the standard version, the C10 output signal for nominal (rated) forces of
2.5 kN to 10 kN is 2 mV/V, and for all other nominal (rated) forces (25 kN to
1 MN), 4 mV/V. If required, the C10 can also be calibrated to half the output
value, for half the nominal (rated) force. With this option, a C10/250kN has
a calibration of 2 mV/V for 125 kN, instead of 4 mV/V for 250 kN.
4. Transducer identification
You can order the force transducer with transducer identification ("TEDS").
TEDS (Transducer Electronic Data Sheet) allows you to store the
transducer data (characteristic values) in a chip that can be read by a
connected measuring device (with an appropriate amplifier). HBM records
the TEDS data before delivery so that no parameterization of the amplifier
is necessary. Each measuring bridge has a TEDS in the double bridge
version. Also see Page 27.
5. Mechanical design
You can purchase the force transducer without an adapter. With an
adapter, the force transducer can be operated without additional mounting,
it is enough to place it on a stable substructure. Without an adapter, a
bolted connection is required. Please comply with Chapter 6
"Mechanical installation" on Page 16.
C10
Scope of supply and design variants
A04036_01_YI0_03 HBM: public
9