Overview: [Circuit Parameters] - ECOLAB DryExxEco Advanced-ETH Betriebsanleitung

10.7

Overview: [Circuit Parameters]

The
screen" (start screen)" on page 54can be used to switch over to the „Circuit Parameters" .
In [Circuit Parameters] the parameter setting of the lubricant circuits of the system are set.
Only sections (plants) to which valves have been allocated are displayed.
Fig. 35: Overview: [Circuit Parameters]
1. In the „home screen"
use the
ð The screen switches to the display „Parameter: section selection" .
2. Press either [Section 1] or [Section 2] .
ð The „Circuit Selection" is displayed.
3. Press either [Circuit 1], [Circuit 2] or [Circuit 3] .
ð The settings for the selected „section" and „circuit" are displayed.
4. Press the button [Times] .
ð The settings for the „valve times" and „pause times" are displayed.
5. Press the button [Boost Times] .
ð The setting for activating the „valve times" is displayed.
button on the start screen of the control
Ä Chapter 10.3 „ „home screen" (start screen)" on page 54
button to switch to the parameter selection.
Layout of the software display
Ä Chapter 10.3 „ „home
69
Overview: Circuit Parameters
Rev. 02-09.2017