Setting The Display Brightness; System Settings" [Installation] - ECOLAB DryExxEco Advanced-ETH Betriebsanleitung

10.4.2

Setting the display brightness

The /
conditions:
n increases the display brightness.
n reduces the display brightness.
10.4.3

„System settings" [Installation]

The „System settings" [Installation] is used to reset the system to the factory settings.
NOTICE!
All settings in the menu: „System settings" [Installation] are only permitted to be
made following consultation with the manufacturer and only by authorised
personnel.
Fig. 16: „System settings" [Installation]
1. button [Installation] Press to retrieve the installation data.
ð A warning message to delete / reset the data ranges is displayed and it is
possible to select between the data range "Part 1" = valve assignment"
and "Part 2" = consumption archives.
2. Press button [delete part 1] .
ð The screen changes to the installation data part 1.
3. Press button [delete part 1] .
ð The valve assignment of the system is reset.
4. Press button [delete part 2] .
ð The screen changes to the installation data part 2.
5. Press button [delete part 2] .
ð The consumption archives of the system are reset.
buttons can be used to adjust the display brightness for the site
57
Layout of the software display
System settings > System settings Installation
Rev. 02-09.2017