Home Screen" (Start Screen); System Settings - ECOLAB DryExxEco Advanced-ETH Betriebsanleitung

Layout of the software display

System settings

10.3

„home screen" (start screen)

After connecting the power supply by switching on the main switch on the control cabinet
(see Ä Chapter 9 „DryExxEco control
will be the „home screen" . From this „home screen" you can call up all the settings on the
control.
The home screen displays the following:
Fig. 13: Start screen
1 Status display / message: „No fault within the control" .
2
The manufacturer logo
button to switch over to the „System settings" .
Ä Chapter 10.4 „ „System settings" " on page 54
3 Type of software control: „DryExx Eco Advanced-ETH"
4
OFF" .
Ä Chapter 10.5 „[Statistics]" on page 65
5
Ä Chapter 10.6 „Overview: [Archive]" on page 65
6
Parameters" .
10.4 „System settings"
Access to the „System settings" on the control is not immediately visible and is
hidden behind the manufacturer logo. Pressing the manufacturer logo
[ECOLAB] calls up the „System settings" .
Fig. 14: System settings
1
switches back over to the „home screen" .
Rev. 02-09.2017
Button to switch over to „Statistics ON/
Button to switch over to the Archive
Button to switch over to „Circuit
® Advanced-ETH" on page 49, Pos. 2), the display
Ä Chapter 10.7 „Overview:
[Circuit Parameters]" on page 69
acts as a
7
Ä Chapter 10.9 „[Messages]" on page 76
8
Ä Chapter 10.10 „Control: Logout" on page 77
9
Parameters" .
Ä Chapter 10.8 „Overview:
[General parameters]" on page 72
10 Display of the valves integrated into the system.
11
Ä Chapter 10.11 „LED Test" on page 77
12 Current set date date and time
Ä Chapter 10.3 „ „home screen" (start
screen)" on page 54
54
Button to switch over to „Messages" .
Button to „logout" from the system.
Button to switch over to „General
Button to run the „LED test" .