Connection
Electrical connection: Control: DryExxEco® Advanced-ETH
7.2
Connection overview for switch cabinet
Switch cabinet view: INTERNAL
Fig. 9: Switch cabinet - connections and interior fittings
1
Power supply in line with enclosed circuit diagram
2
Inputs, outputs, cabling in line with enclosed circuit
diagram
The connection of the elements in the switch cabinet should be carried out only
by specialist personnel and in line with the specifications on the circuit diagram
(included).
7.3
Electrical connection: Control: DryExxEco
Personnel:
If the applicator station and control unit are not supplied from the factory on a standard
console ready for connection, then all electrical connections shown in the connection
diagram, cable lists and circuit diagram of the DryExx® control unit must be supplied
WARNING!
Before the master switch is switched on, ensure that voltage and frequency
supplied match the information on the appliance rating plate.
Before any connection work, the system must be disconnected from the mains
and protected against being switched back on.
1.
Connect the power supply in line with enclosed circuit diagram.
2.
Connect the inputs and outputs according to the plant size and in line with the
enclosed circuit diagram.
Rev. 02-09.2017
n
Manufacturer
Qualified electrician
n
42
®
Advanced-ETH
®
.