Overview: [General Parameters] - [Operating Mode] - ECOLAB DryExxEco Advanced-ETH Betriebsanleitung

Layout of the software display
Overview: General parameters > Overview: General parameters - operating mode
10.8.2

Overview: [General parameters] - [operating mode]

The control of the operating modes available here is carried out.
Fig. 41: Overview: [General parameters] - [operating mode]
1 The [Automatic System] after the control is switched on
is always switched to [ON] (green).
2 Automatic is deactivated [OFF] (grey) and the system
can be controlled manually.
1. In the „home screen"
use the
ð The overview: „Parameters: General" is displayed.
Ä Chapter 10.8.1 „[General parameters]" on page 73
2. Press button [operating mode] .
ð The overview: „Operating modes" is displayed.
Rev. 02-09.2017
Ä Chapter 10.3 „ „home screen" (start screen)" on page 54
button to switch to the general parameters.
Only when in this view the button [Monitor Dosing quantity] on [ON]
(green) is switched on, the additional button appears
[Monitor Consumption] (Pos. 5)!
74
3 Deactivate all operating mode functions.
4 Controls the monitoring and display of the consumption
data. The button [Monitor Consumption] only appears if
[Monitor Dosing quantity] is switched to [ON] (green).
5 Monitoring and display of the consumption data.