Drilling Table; Drill Chuck Protection; Prohibition, Warning And Mandatory Signs; Safety Check - Optimum OPTIdrill B 40GSP Betriebsanleitung

1.9.3

Drilling table

Seats for T-slots are attached to the drill-
ing table.
WARNING!
Risk of injury due to parts flying off at
high speed. Securely fix the workpiece
on the drilling table.
1.9.4

Drill chuck protection

Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and re-tighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that
the cover is closed.
INFORMATION
You cannot start the machine if the drill
chuck protection is not closed.
1.9.5

Prohibition, warning and mandatory signs

INFORMATION
All warning signs must be legible. Check them regularly.
1.10

Safety check

Check the geared drill before each start-up or at least once per shift. Inform the person respon-
sible immediately of any damage, defect or change in operating function.
Check all safety devices

at the beginning of each shift (with the machine stopped),

once a week (with the machine in operation),

after every maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the geared drill

are legible (clean them, if necessary),

are complete (replace if necessary).
EN B40 GSP
64
Seats for clamping
blocks
Integrated position
switch
Clamping screw
Drill chuck protection
Translation of original instruction
Img.1-4: Drilling table
Img.1-5: Drill chuck protection
Version 2.1.2 - 2021-09-22
Safety