1.9.3
Drilling table
Seats for T-slots are attached to the drill-
ing table.
WARNING!
Risk of injury due to parts flying off at
high speed. Securely fix the workpiece
on the drilling table.
1.9.4
Drill chuck protection
Adjust the drill chuck protection to the
required height.
Fold the drill chuck protection into place
before you start drilling.
The geared drill must only be switched
on, if the drill chuck protection is closed.
1.9.5
Prohibition, warning and mandatory signs
INFORMATION
All warning signs must be legible. Check them regularly.
1.10
Safety check
Check the geared drill at least once per shift. Inform the person responsible immediately of any
damage, defect or change in operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
once a week (with the machine in operation),
after every maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the geared drill
are legible (clean them, if necessary),
are complete.
INFORMATION
Use the following table in order to organize the checks.
Safety
Version 1.1.4 - 2021-01-04
seats for clamping
blocks
( 18 mm )
Img.1-4:
Drill chuck protec-
tion
Img.1-5:
Translation of original instruction
Drilling table
Drill chuck protection
B50 GSM
EN
69