Commissioning
Commissioning
Mounting instructions
Mounting the support rod
The support rod allows you to attach
the stirrer to a stand or to a wall grid.
(see chapter "Accessories and spare
parts, Accessories").
Scope of delivery:
–
Support rod
–
Allen key
On the back of the device you will find
a slot for the support rod.
➜
Push the support rod into the slot
on the back of the device with the
notch facing the front.
➜
Make sure that the notch on the
support rod aligns with the grub
screw in the housing.
➜
Secure the support rod using the
Allen key provided.
Mounting the quick chuck
➜
Remove the impeller, if currently
in place.
➜
Close the quick chuck and push
the safety ring up into the top
position.
➜
Slightly loosen the grub screw
located in the orange ring using
the Allen key.
➜
Pull the quick chuck down to
remove.
➜
When re-mounting, ensure the
grub screw aligns with the recess.
Support rod
Allen key
Grub screw
housing
Notch
Allen key
Safety ring upper
position
Grub screw
Recess for grub
screw
Grub screw
Allen key
68
Notch