Special Accessory Installation; Determining The Installation Type; Choice Of Location - Truma Mover S Gebrauchsanweisung

A distinction is made between L-profiled and U-profiled
chassis as shown in the illustration.
Caravan floor
L-profi i le
Measuring the chassis height
Frame height (Y) measured at distance of 106 mm (X) from the
outer edge of the tyre at height of hub/middle of tyre.

Determining the installation type

1. Standard installation
Standard installation is used with a U-profile or L-profile chas-
sis and a frame height (Y) of approx. 185 mm. No special ac-
cessories are required.
2. Installation with chassis with U-profile or L-profile and
frame height of between 140 and 185 mm
With a chassis with a frame height (Y) of 140 mm to 185 mm,
1, 2 or 3 spacer plate sets and the screw set are needed to
compensate for the height.
3. Installation with chassis with U-profiles or L-profiles
with frame height of less than 140 mm
With a chassis with a frame height (Y) of less than 140 mm a
low chassis kit must be fitted to compensate for the height.
In Germany, the low chassis kit installation must be
accepted by a vehicle expert.
4. The AL-KO Vario III / AV installation kit must be used
with the AL-KO Vario III / AV chassis with a frame thickness of
less than 2.8 mm.
5. Installation with Eriba Touring chassis
The Eriba Touring mounting set is needed for the Eriba Touring
chassis.
16
U-profile

Special accessory installation

1. Set of screws
for height compensation with
spacer plates, max. 45 mm
eight DIN 933 screws
M 10 x 95 8.8, galvanized,
Part no. 60010-70000.
2. Spacer plate kit
(two 15 mm spacer plates)
for height compensation
max. 45 mm (3 Plates) at each
side (e.g. installed behind axle)
Part no. 60010-66000.
3. Low chassis kit
For height compensation for
caravan/trailer with frame height of
less than 140 mm,
Part no. 60010-64900.
In Germany, this installation
kit must be accepted by a
vehicle expert.
4. AL-KO Vario III / AV
Installation kit
For caravans with
AL-KO Vario III / AV Chassis
(frame thickness less than
2,8 mm) mandatory,
Part no. 60010-21500.
5. Mover mounting set
for Eriba-Touring
Part no. 60010-72000.
Installation is not possible in
some cases because of
attachments to the underbody.
Contact your dealer if necessary.
Detailed installation instructions are provided with the
relevant mounting set.
The Mover S is not approved for installation on
caravans/trailers with any other chassis!
Any drilling (exception: when using flat frame kit) or welding
to the chassis is not allowed. Under no circumstances remove
any suspension components from the chassis.

Choice of location

The Mover should preferably be installed in front of the axle,
but can also be installed behind the axle under special circum-
stances (e.g. lack of space). Only the bolts that are provided
must be used to secure the Mover (or the add-on parts provided
as special accessories).
c