Function Description; Changing The Batteries In The Remote Handset; Manoeuvring The Caravan - Truma Mover S Gebrauchsanweisung

Function description

Always observe the operating instructions and „Safety-
related instructions" prior to starting! The vehicle owner is
responsible for correct operation of the appliance.
Note that only single axle caravans are suitable.
The Mover is a manoeuvring system with which a caravan can
be moved without the assistance of a towing vehicle.
It consists of two separate drive units, each of which has a
12 Volt DC motor. These units are attached to the frame of the
vehicle near the wheels and are connected by lateral bars.
Once the drive rollers have been swivelled onto the tyres using
the provided lever, the Mover is ready for operation. All opera-
tion takes place using the remote hand set. This transmits radio
signals to the control unit. A separate 12 V lead-acid battery or
suitable lead-gel battery (not included in scope of delivery) sup-
plies the control unit with current.
Remote Handset
The caravan can be turned in a circle on the spot without
moving forward:
d + g = Turn caravan to the right
(left wheel rotates forwards + right wheel rotates
backwards)
e + f = Turn caravan to the left
(left wheel rotates backwards + right wheel rotates
forwards)
The remote hand set automatically switches itself off after ap-
prox. 40 seconds if no button is pressed, or after 5 minutes if
one of the movement buttons is permanently held down. The
green LED goes off.
To reactivate the remote control, move slide switch to „Off"
and then back to „On" after approximately 1 second.
!
There is no „On/Off" switch on the caravan to be operated.
a = On/Off slide switch
On (green LED illuminates)
!
o
Off (green LED goes off)
b = Caravan forwards
(both wheels rotate in
forwards direction)
c = Caravan reverse
(both wheels rotate in
reverse direction)
d = Caravan right forwards
(left wheel rotates in
forwards direction)
e = Caravan left forwards
(right wheel rotates in
forwards direction)
f = Caravan right reverse
(left wheel rotates in
reverse direction)
g = Caravan left reverse
(right wheel rotates in
reverse direction)

Changing the batteries in the remote handset

No claims under guarantee will be considered for damage
caused by leaking batteries.
Before throwing away a defective handset, it is essential that
the batteries are removed and disposed of in proper manner.

Manoeuvring the Caravan

Please read the „Safety-related instructions" before
using the Mover!
1. With the caravan uncoupled (apply handbrake), apply drive
rollers to the tyres using the provided lever. Swivel the lever
until it cannot be swivelled any further without using excessive
force. The drive unit securely engages in the end position.
Before operating the Mover, release the handbrake.
2. Move slide switch (a) on remote hand set to the „On"
tion. The Mover is ready for operation after about 5 seconds.
3. The six direction buttons provide movement in six direc-
tions – forward, reverse, left forward, left reverse, right for-
ward, right reverse.
The „left forward" (e) and „right reverse" (f) or „right forward"
(d) and „left reverse" (g) buttons can also be pressed simulta-
neously in order to turn the caravan in a circle on the spot
without moving it forwards.
The Softstart makes the caravan start to move without
jolting.
4. If the buttons are released or the radio signal is interfered
with or becomes too weak, the caravan stops. Your Mover can-
not be activated by radio devices or other Mover remote hand
sets.
5. After starting up, the Mover moves at one speed only. The
speed will increase a little when going downhill and decrease a
little when going uphill.
6. Move slide switch on remote control to the „Off"
to switch the remote control and the Mover off.
The slide switch also acts as an „Emergency stop"
switch.
o
7. After manoeuvring, first apply the handbrake and then
swivel the drive rollers away from the tyres.
Please be sure to use leak proof micro -
batteries only, type LR 03, AAA, AM 4,
MN 2400 (1.5 V).
When fitting new batteries ensure the
polarity is correct!
Dead and used batteries may leak
and damage the remote handset!
Remove the batteries if the handset is not
going to be used for an extended period.
posi-
!
o
position
13