Special Accessory Installation; Selecting A Location; Fitting The Drive Elements - Truma Mover XT4 Gebrauchsanweisung

Special accessory installation

1. 30 mm spacer set
For compensating for height on caravans / trailers with
a frame height of < 140 mm down to 110 mm, part no.
60030-95000.
Fig. 9
2. 60 mm spacer set
For compensating for height on caravans / trailers with
a frame height of < 110 mm down to 80 mm, part no.
60030-95100.
Fig. 10
3. Low chassis kit
For compensating for height on caravans / trailers with a
frame height of less than 80 mm and / or for bridging struts,
part no. 60010-64900.
Fig. 11
If this installation kit is used in Germany, acceptance
by a vehicle expert is required.
4. Low chassis kit, short
Fig. 12
For compensating for height on caravans / trailers with
a frame height of less than 80 mm,
part no. 60030-37600.
If this installation kit is used in Germany, acceptance
by a vehicle expert is required.
22
In some cases installation is not possible because of the
design of the sub-frame. Contact your dealer if
necessary.
Detailed installation instructions are included with each
mounting set.
The Mover® XT4 must not be fitted to caravans /
trailers with other frames.
The vehicle frame must not be drilled (except when using the
low chassis kit) or welded. Wheel suspension parts must not
be removed under any circumstances.

Selecting a location

Only use the bolts provided (or the mounting parts available
as special accessories) to attach the Mover® XT4.

Fitting the drive elements

The frame of the vehicle must be free of rust, grease and
heavy soiling. There must be no damage in the area of the
wheel suspension.
The wheels and tyres fitted on the caravan must be of the
same size and type, and must be inflated in accordance with
manufacturer's instructions.
Remove all components from packing and place on the floor.
Fig. 16
In order to guarantee the validity of the general operat-
ing permit (ABE), the left and right data plates (f) must
be present on the cross-struts (4x).
Fig. 17
Loosely connect the drive assemblies and the cross-struts.
Tighten the nuts (lock nuts), but no more than finger-tight.
Nut M8 (2 x)
Fig. 18
f
M8 x 30 (2 x)