Special Accessory Installation; Choice Of Location; Installation Of The Drive Units - Truma Mover TE R4 Gebrauchsanweisung

Special accessory installation

1. Spacer set 30 mm
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 170 mm
and up to140 mm,
part no. 60030-95000.
2. Spacer set 60 mm
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 140 mm
and up to 110 mm,
part no. 60030-95100.
3. Low chassis kit
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 110 mm
and / or for bridging struts,
part no. 60010-64900.
In Germany, this installationkit
must be accepted by a vehi-
cle expert.
3a. Low chassis kit, short
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 110 mm,
part no. 60030-37600.
In Germany, this installation
kit must be accepted by a
vehicle expert.
4. AL-KO Chassis M Adapter set
Mounting set to compensate the
frame edges for caravans with
AL-KO Chassis M,
part no. 60030-38600.
Detailed installation instructions are provided with the
relevant mounting set.
The Mover® TE R4 is not approved for installation
on caravans / trailers with any other chassis!
Any drilling (exception: when using low chassis kit) or welding
to the chassis is not allowed. Under no circumstances remove
any suspension components from the chassis.

Choice of location

The Mover® is mounted in front of the first axle and behind the
second axle. Only the bolts that are provided must be used
to secure the Mover® (or the add-on parts provided as special
accessories).
20

Installation of the drive units

The frame of the vehicle must be kept free of rust and heavy
soiling and without any damages to the suspension
components.
The wheels and tyres that are fitted to the caravan must be of
the same size and model and inflated as per the manufacturer's
instructions.
Remove all components from packing and place on the floor.
To ensure the validity of the General Vehicle Type Ap-
proval, the 4 enclosed factory plates (f) need to be at-
tached on the left and the right of the cross bar between the
holding plates of the drive units.
Loosely attach the drive units to the lateral bar. The bolts
(lock nuts) must be no more than finger-tight.
Nut M8 (4 x)
Place the drive units with the crossbar and attachment set (b)
onto the vehicle frame and screw tight with the two screws (c)
so that it is just possible to slide along the frame.
b
f
M8 x 30 (4 x)
c