Minimum Installation Dimensions; Measuring The Frame Height; Determining The Installation Type; Special Accessory Installation - Truma Mover SR Gebrauchs- Und Einbauanweisung

Minimum installation dimensions

A distinction is made between L-profile and U-profile
frames as shown in the illustration.
Caravan floor
L-profile
Figure 5
Installation is only possible on caravans / trailers with the fol-
lowing dimensions.
Caravan floor
170
min. 25
min. 35 **
min. 50 / max. 180
min. 1200 / max. 2000
Figure 6
All dimensions in mm.
* with loaded vehicle with max. permissible gross weight
** with U-profile

Measuring the frame height

A frame height of at least 170 mm is required at the level of
the tyre hub / tyre centre in the range of 340 mm from the
outer edge of the tyre.
Figure 7

Determining the installation type

1. Standard installation
Standard installation is used with a U-profile or L-profile chas-
sis and a frame height of at least 170 mm. No special access-
ories are required.
2. Installation on chassis with U-profile or L-profile
and a frame height of between 110 mm and less than
170 mm
In order to compensate for height, the 30 mm spacer set (for
frame heights down to 140 mm) or the 60 mm spacer set (for
frame heights of less than 140 mm) is required.
3. Installation on chassis with U-profiles or L-profiles
with a frame height of less than 110 mm
If the chassis has a frame height of less than 110 mm, a low
chassis kit must be fitted to compensate for the height.
If a low chassis kit is used in Germany, accept-
ance by a vehicle expert is required.
4. For the AL-KO Vario III / AV chassis with a frame thickness
of less than 2.8 mm it is essential to use the AL-KO Vario III /
AV installation kit as a reinforcement.
5. For attachment in front of the axle on the AL-KO
chassis M with adjustable beams
The AL-KO chassis M adapter set (part no. 60030-38600)
must be used in order to compensate for overlapping frame
edges.
U-profile
min. 170
340
6. For attachment in front of the axle on the AL-KO
chassis M with continuous frame
The AL-KO chassis M adapter set (part no. 60031-02000)
must be used in order to compensate for overlapping frame
edges.
7. Installation on the Eriba Touring chassis
It is essential to use the Eriba Touring mounting set for the
Eriba Touring chassis.
8. Installation on chassis with L-profile and with a lim-
ited amount of space
The short mounting system is required to compensate for
the height (30 or 60 mm) with substructures such as tanks.

Special accessory installation

1. Spacer set 30 mm
For compensating for height on caravans / trailers with
a frame height of < 170 mm to 140 mm,
part no. 60030-95000.
Figure 8
2. Spacer set 60 mm
For compensating for height on caravans / trailers with a
frame height of < 140 mm down to 110 mm,
part no. 60030-95100.
Figure 9
3. Low chassis kit
For compensating for height on caravans / trailers with a
frame height of less than 110 mm and / or for bridging struts,
part no. 60010-64900.
Figure 10
If this installation kit is used in Germany, acceptance
by a vehicle expert is required.
4. Low chassis kit, short
For compensating for height on caravans / trailers with a
frame height of less than 110 mm,
part no. 60030-37600.
19