Special Accessory Installation; Choice Of Location; Installation Of The Drive Units - Truma Mover Se R Gebrauchsanweisung

Special accessory installation

1. Spacer set 30 mm
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 170 mm
and up to 140 mm,
part no. 60030-95000.
2. Spacer set 60 mm
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 140 mm
and up to 110 mm,
part no. 60030-95100.
3. Low chassis kit
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 110 mm
and / or for bridging struts,
part no. 60010-64900.
In Germany, this installation
kit must be accepted by a
vehicle expert.
3a. Low chassis kit, short
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 110 mm,
part no. 60030-37600.
In Germany, this installation
kit must be accepted by a
vehicle expert.
4. AL-KO Vario III / AV
Installation kit
For caravans with
AL-KO Vario III / AV Chassis
(frame thickness less
than 2,8 mm) mandatory,
part no. 60010-21500.
4a. AL-KO Chassis M Adapter set
Mounting set to compensate the
frame edges for caravans with
AL-KO Chassis M,
part no. 60030-38600.
5. Mover® mounting set
for Eriba-Touring,
part no. 60030-09000.
Installation is not possible in
some cases because of
attachments to the underbody.
Contact your dealer if necessary.
Detailed installation instructions are provided with the
relevant mounting set.
The Mover® SE R / TE R is not approved for instal-
lation on caravans / trailers with any other chassis!
No holes may be drilled into or welding work performed on
the vehicle frame (except when using the low chassis kit* and
the Eriba-Touring mounting set). Under no circumstances re-
move any suspension components from the chassis.
* In the case of the AL-KO Vario III / AV Chassis, never drill
into the vehicle frame even if the flat frame kit is used.

Choice of location

The Mover® should preferably be installed in front of the axle,
but can also be installed behind the axle under special circum-
stances (e.g. lack of space). Only the bolts that are provided
must be used to secure the Mover® (or the add-on parts
provided as special accessories).

Installation of the drive units

The frame of the vehicle must be kept free of rust and heavy
soiling and without any damages to the suspension
components.
The wheels and tyres that are fitted to the caravan must be of
the same size and model and inflated as per the manufacturer's
instructions.
Remove all components from packing and place on the floor.
In order to maintain the validity of the General Operating
Permit (ABE) the provided factory plates (f) must be at-
tached on the left and right sides of the cross strut between
the drive unit retaining plates.
Loosely attach the drive units to the lateral bar. The bolts
(lock nuts) must be no more than finger-tight.
Nut M8 (4 x)
f
M8 x 30 (4 x)
21