Warning Information; Commissioning The Mover - Truma Mover S Gebrauchsanweisung

Route battery connecting cables (10 mm
securely attach using the provided clips and screws.
View from top
B B
A
A
View from top +
A
A
-
+
B
B
-
Route battery connecting cables so that they do not
chafe (particularly at leadthroughs through metal panels).
Use water hoses or leadthrough grommets to prevent damage
to cables. Connect battery connecting cables to the existing
battery terminals (red = positive, black = negative).
Re-check whether all cables are correctly connected, attached
using the provided clips and cannot chafe.

Commissioning the Mover

1. Ensure the battery used to operate the Mover is fully
charged.
2. Park the caravan outside on an open, level surface and ap-
ply the handbrake. Ensure that the rollers are disengaged from
the road tyres and the corner steadies are raised.
3. Connect battery terminals to battery, check that all cables
are secure and not hot or indicating signs of short circuits, etc.
4. Move slide switch on remote control to the „On"
This switches the remote control on and the LED illuminates.
If LED does not illuminate, check polarity and condition of bat-
teries in remote control. The remote control switches itself off
after about 40 seconds if no buttons are pressed.
5. Check whether both drive motors are stationary. With the
remote hand set switched on, and no more than 2 m away
from the control unit, press the „Forwards" button. Both drive
motors must now move in the forwards direction.
6. Move slide switch on remote control to the „Off"
to switch the remote control and therefore the Mover off.
7. Move drive rollers against the tyres using the provided
swivelling lever. Turn the swivelling lever until it mechanically
engages and cannot be turned any further without using
excessive force (end position approximately horizontal).
8. Ensure that there no obstacles around the caravan, release
the handbrake and switch the remote control on. Now check all
functions several times according the operating instructions.
9. Move slide switch on remote hand set to the „Off"
tion to switch the remote hand set and the Mover off. Apply
caravan brake. Release drive rollers using swivelling lever and
re-check distance between roller and tyre. Adjust if necessary.
The distance between the swivelled-out drive rollers and
the tyres is 20 mm.
) to control unit and
2
4 3 2 1
+ -
-
+ red black
-
+
4 3 2 1 + -
-
black
red
+
-
+
! position.
o
position
o
posi-

Warning information

The yellow sticker with the warning information, which is en-
closed with the appliance, must be affixed by the installer or
vehicle owner to a place in the vehicle where it is clearly visible
to all users (e.g. on the wardrobe door)! Ask Truma to send you
a sticker, if necessary.
Technische Daten
Designation:
Area of operation:
Operational voltage:
Current consumption:
Stand by consumption:
Remote hand set
frequency:
Speed:
Weights:
Right to effect technical modifications reserved!
Mover S
Single axle caravans with a
total weight up to 1800 kg
12 V DC
Average approx. 20 A
Maximum 120 A
< 15 mA
Class 1, 433.92 MHz
Approx. 16 cm per second (de-
pending on weight and incline)
Approx. 35 kg (including cross
actuation device)
19