Special Accessory Installation; Selecting A Location; Mud Guards - Truma Mover XT4 Gebrauchsanweisung, Einbauanweisung

Special accessory installation

1. Spacer kit 30 mm
To compensate for the height for caravans with a frame
height of < 140 mm to 110 mm,
part no. 60030-95000.
Figure 9
2. Spacer kit 60 mm
To compensate for the height for caravans with a frame
height of < 110 mm to 80 mm,
part no. 60030-95100.
Figure 10
3. Low chassis kit
For compensating for height on caravans with a frame height
of less than 80 mm and / or for bridging struts,
part no. 60010-64900.
Figure 11
If a low chassis kit is used in Germany, acceptance
by a vehicle expert is required.
4. Low chassis kit, short
For compensating for height on caravans with
a frame height of less than 80 mm, part no. 60030-37600.
Figure 12
If a low chassis kit is used in Germany, acceptance
by a vehicle expert is required.
24
5. Short mounting system
Replacement for standard mounting system if this cannot be
used due to lack of space and to compensate for the height
(30 or 60 mm) of substructures such as tanks.
Part no. 60031-20000.
Figure 13
6. Mud guard set (no illustration)
Replacement for the standard mud guards, if these cannot be
adapted to the Mover®.
Part. no. 60031-08200
In some cases installation is not possible because of the
design of the sub-frame. Contact your dealer if
necessary.
Detailed installation instructions are included with each
mounting set.
The Mover® XT4 must not be fitted to caravans
with other frames.
The vehicle frame must not be drilled (except when using a
low chassis kit) or welded. Wheel suspension parts must not
be removed under any circumstances.

Selecting a location

Only use the bolts provided (or the mounting parts available
as special accessories) to attach the Mover® XT4.

Mud guards

When a Mover® is fitted, the existing mud guards must be
moved / adapted if necessary (max. distance between tyre /
mud guard 300 mm).
If the original mud guards cannot be used, the Truma mud
guard set (part no. 60031-08200) must be used and adapted.
The mud guards are installed behind the axle. No mud
guards are required in front of the axle.
Mover® XT4
Driving direction
Figure 14
max.
300 mm
Mover
max. 200 mm