Automatic Updates; Menu Structure And Navigation - Canton Smart Soundbar 10 Bedienungsanleitung

English

Automatic Updates

After you have connected the Soundbar 10 to the network, firmware updates are executed automatically. After each connection to the power supply
and at regular intervals (also in standby mode), the Soundbar 10 searches for an update and installs this, if available. The LED flashes green/red
during the update and the display first shows „DOWNLOADING", then „UPDATING". During this time the Soundbar 10 is not operable.
To do this, the Soundbar 10 must have been connected to the network router via the Google Home app or an iOS device (by use of WLAN) or
alternatively by a network cable (by use of LAN).
Attention: Do NOT disconnect the Soundbar 10 from the power supply during an update process!

Menu Structure and Navigation

Overview
Most settings of the Smart Soundbar 10 are included into the main menu. This settings menu is controlled by the infrared remote control delivered
with the device. The settings menu is displayed by the OSD (On Screen Display). The LED display in the Soundbar shows the respective function in
the form of an abbreviation when the menu is activated. This means that the Soundbar can also be adjusted without a screen. Below, please find an
instruction how to navigate through the menu:
• To enter the menu, press the "M" button.
• To enter the next menu level, press the "OK" button.
• To navigate upwards or downwards in the menu, press the Up
• To change the value of a parameter, press the "+" (Volume +) or "–" (Volume -) button.
• To enter the previous menu level, press the "M" button.
• To exit the menu:
a) Either press and hold the "M "button until the selected input (e.g. TV) is displayed, or
b) wait for 30sec without pressing any button on the remote control.
Practical tip:
• To change the language of the On-screen display from German to English, please go to the main menu by pressing the button „M".
Under „Systemeinstellung" [SYS] select the menu item „Displayeinstellungen" [UIS] and change the language under the menu item „Sprache"
[LAN].
86
" " or Down " " key.