Standby Mode [Stb] - Canton Smart Soundbar 10 Bedienungsanleitung

- Volume/Mute: The volume of the Soundbar 10 can be operated using the Mute and Volume buttons of the TV remote control.
To activate/deactivate this function, proceed with the following steps:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to choose the function CEC [CEC] and confirm with the "OK" button.
3
Use the "+" or "–" button to select [OFF] to disable the CEC functionality resp. [ON] to enable it and confirm with the "OK" button.
4
Press the "M" button to exit this menu item.
5
Notes: • Many device manufacturers have developed their own protocols for controlling their devices based on the CEC standard. This can mean
that the functions described above only function partially, or do not function at all.
• In order to avoid conflicts when controlling the Smart Soundbar 10, the "Volume +/-", "Mute" and "Power" buttons on the TV remote
control should not be learned through the IR learn function of the Soundbar when using the CEC function. Delete the codes if necessary.

Standby Mode [STB]

This function controls, how the Soundbar 10 powers up resp. down - manually or automatically, partly dependent on an incoming audio signal. The
Soundbar 10 supports the following fuctions:
• ECO [ECO]: If ECO is selected, the Soundbar enters standby mode after 20 minutes without any detected audio signal at the selected input
and needs to be powered up manually using the remote control.
• Network [NSB]: If Network [NSB] is selected, the Soundbar must be turned on manually and will automatically enter standby after 20 minutes
without detected audio at the selected input. However, there is a difference to the ECO mode, as described below. Network [NSB] is the default
setting of the Soundbar 10.
• Auto [AUT]: If Auto is selected, the Soundbar turns on automatically if an audio signal is detected at any input. If no signal is detected any lon-
ger, the Soundbar enters standby mode after 1 minute (at the digital inputs Optical, Coaxial, and Bluetooth) resp. 15 minutes (at the analog input
AUX).
• Manuell [MAN]: If Manual is selected, the Soundbar stays active permanently and must be powered up and down manually, using the remote
control.
If ECO is selected, all wirelessly connected speakers will be powered down automatically, but each speaker must be powered up individually. This is
the operation mode with the lowest standby power consumption. All the other modes Network, Auto, and Manual provide an automatic power up
function for all wirelessly connected speakers when powering up the Smart Soundbar 10 (Master Device). You can find additional information in the
description in the "Sub Output" and "Wireless Speaker Pairing" part.
English
3 9 7