Canton Smart Soundbar 10 Bedienungsanleitung Seite 120

English
Problem
The Soundbar 10 does
not change inputs
automatically.
The device uninten-
tionally changes the
input.
Paired wireless spe-
akers do not turn on
together with the
Soundbar.
An input cannot be
selected via the Input
buttons.
120
Possible cause
1. The source device on the coaxial or optical digi-
tal input has not been switched off or the source
device does not switch off its S/PDIF transmitter
in standby mode.
2. The signal at the AUX (Line), input is too low.
1. This can happen if the function Input Select [SEL]
is set to AUT and the currently selected input
AUX (Line) has a long break in the playback (>10
seconds) and a signal is present at another input
or the source device is turned on at the optical
and coaxial input.
2. This can happen when your (mobile) device
issues system sounds, such as typing on the
keyboard.
1. The speakers are not paired.
2. The parameter Standby [STB] is set to ECO.
1. The input was deactivated in the Input Config
[INP] menu (---).
Solution
1. In order to switch from the coaxial or optical digital input,
the source device must be switched off resp. disconnected
from the mains.
2. Increase the output level on your source device.
1. Make sure that no signal is present at any other input
during playback at the Line, Balanced and USB inputs or
that a device is switched on at the optical and coaxial
digital input.
2. Disable these system sounds on your device.
2.2 Set Input Select [SEL] resp. BT Select function to MAN.
(manual).
1. Pair all slave speakers according to chapter
WSP (Wireless Speaker Pairing).
2. If the parameter STB is set to ECO, each speaker must be
switched on separately with the remote control. If you want
to switch all speakers on together, set the parameter to NSB,
MAN or AUT.
1. Activate the input according to chapter Input Config [INP].