Bluetooth ® Wireless - Canton Smart Soundbar 10 Bedienungsanleitung

English
Problem
The BT input cannot be
selected via the "Input"
buttons.
The Soundbar 10 does
not automatically
switch to the BT input.
No playback via
Bluetooth wireless
®
technology.
118
Possible cause
1. The function BT Select [BTS] is activated.
1. The BT Select function is deactivated (MAN).
2. Bluetooth is disabled on your device.
®
3. The Soundbar 10 is connected to another device.
4. The device is not paired with the Soundbar 10.
1. There is no connection between the Soundbar 10
and the (mobile) device.
2. The (mobile) device is paired, but it does not
play.
3. You are out of reach (max. 10 m).
Solution
1. The switching happens in this case automatically as soon as
the Soundbar 10 detects an audio signal from the device.
If unwanted, set BT Select (BTS) to manual.
1. Activate the BTS function (AUT).
2. Activate Bluetooth on your device.
®
3. Disable Bluetooth on the other device.
®
4. Pair your device with the Soundbar 10.
1. Connect the (mobile) device as described.
2.1 The (mobile) device needs to be reconnected.
2.2 Set the volume on the (mobile) device to the
maximum possible value.
2.3 Increase the volume of the Soundbar 10.
2.4. Make sure that sources of interference, such as a
WiFi router or a laptop, are not placed in close proximity
to the Soundbar 10.
2.5. Simultaneous operation via WiFi and Bluetooth
connection from a (mobile) device is not possible
without interference in some cases; therefore, disable
WiFi on the device.
3. Reduce the distance between the speaker
and the (mobile) device.
®