Canton Smart Soundbar 10 Bedienungsanleitung Seite 117

Problem Possible cause
Soundbar 10 is buzzing. 1. Signal cables from the source device to the
Soundbar 10 are too long (Analog Line).
2. Used signal cable not shielded or the shield on
the cable used is interrupted (defective).
3. Ground loop (hum loop) "generated".
A ground loop can occur if at least two
interconnected devices with safety plugs
(e.g. amplifier and computer) are connected to
locally separated power outlets.
4. A non-interference suppressed consumer
(e.g. fridge) on the same mains phase.
The Soundbar 10 1. This can happen when your (mobile) device
unintentionally issues system sounds, such as typing on the
switches to the BT keyboard.
input.
The Soundbar 10 2. This can happen when your (mobile) device is
unintentionally playing system sounds such as when typing on
switches on. the keyboard, a digital source is turned on, or an
analog source is playing.
Solution
1. Use shorter and/or higher quality signal cables.
2. Replace the cable with a shielded
and/or higher quality cable.
3. Connect all devices connected to the Soundbar 10
with a safety plug to a power strip (multiple socket).
4. For testing purposes, turn off any possible sources of interfe-
rence; have the relevant device suppressed for interference,
if the humming sound disappears, or initially connect the
source of interference to another mains phase (L1, L2 or L3)
(consult a specialist if necessary); Insert a special "sheath
current filter" (available from specialist retailers) between the
amplifier and the Soundbar 10 to eliminate the humming. Turn
the power plug round to reduce the so-called hum voltage
(particularly important
if the source device is not earthed).
1. Deactivate the function BT Select [BTS].
(setting on MAN).
1.1 Disable these system sounds on your device.
2. Change the standby function from AUT to ECO,NSB or MAN.
English
3 1 17