Wireless Reset [Wre]; Rf Power [Txp] - Canton Smart Soundbar 10 Bedienungsanleitung

English
Approx. 10 - 20 seconds after switching on the slave speaker the displays should show [CON] resp. "Connected" at the OSD. From now on the
7
display of the (slave-)speaker and the display of the Soundbar 10 are in sync.
If [FAI] appears in the display, repeat steps 4 - 7 and make sure that...
8
a.) the desired slave speaker was disconnected from the mains for at least 30 seconds.
b.) not more than 30 seconds have been passed between pressing the OK button and witching on the slave speaker.
c.) the distance between the two speakers (soundbar and slave speaker) may not exceed 10 m and they are in the same room.
To pair a further speaker resp. a subwoofer, please repeat steps 4 - 7.
9
Caution: Should you have performed the above steps, never repeat them with the Soundbar 10 (master speaker) switched off, as this will
automatically designate a new master speaker and would prevent the previous slave speakers from connecting to the previously
designated Soundbar 10.

Wireless Reset [WRE]

This functions allows you to delete all stored settings and paired Smart speaker and/or Smart subwoofer (slave speaker) connections of the wireless
audio module of the Soundbar 10 and in this way reset the wireless module.
Caution: All settings and paired Smart speakers / Smart subwoofer that have been made according to the wireless audio module in the
Soundbar 10 will be deleted.
To perfom the reset please do as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu Wireless Setup [WIS] and confirm with the "OK" button.
2
Use the " " or " " button to select the item Wireless Reset [WRE] and confirm with the "OK" button. The menu Wireless Reset is displayed and
3
the status indication should show "No", the display shows [NO].
If you want to cancel the reset precedure, press the "OK" button, or press the "M" button.
4
If you want to perform the reset, select "Reset all" using
5
The OSD shows "Please Wait", the display still shows [YES]. After a few seconds the Soundbar 10 jumps back to the menu "Wireless Setup".
6
Press the "M" button to exit this menu item.
7

RF Power [TXP]

The wireless audio module of the Soundbar 10 is by default set to 25% of the maximum transmission power [ECO], according to -6dB. In most cases,
this is completely adequate for a stable and non-interrupted wireless connection with Smart speakers and/or a Smart subwoofer in the same room.
In case of connection problems and/or audio dropouts you can increase the transmission power. At Medium setting [MED] the transmission power is
at 50% (-3dB) and at [Max] at 100% (0dB).
108
" " or " " key and press the "OK" button. The display shows [YES].