Canton Smart Soundbar 10 Bedienungsanleitung Seite 119

Problem Possible cause
Playback of the Blue- 1. The automatic playback function Autoplay [APL]
tooth device starts is activated (ON).
®
automatically when the
speaker is switched on.
Pairing of wireless spe- 1. The slave speaker was not disconnected or was
akers fails. not disconnected from the mains long enough
before pairing.
2. The slave speaker was in standby mode
during the pairing.
3. The slave was connected to the mains before
the pairing was initialised on the Soundbar
(master speaker).
4. The distance between slave and master
is too high.
Two speakers play the 1. Two slave speakers were assigned the
same channel. same channel when pairing.
Solution
1. Set the Autoplay [APL] function to OFF.
1. Disconnect the slave speaker to be paired for
at least 30 seconds from the mains.
2. After turning on the power switch of the slave speaker resp.
connecting it to the mains, power it up by the remote cont-
rol.
3. Always start pairing at the Soundbar before connecting the
slave to the mains.
4. Reduce the distance between Soundbar and slave speaker.
The maximum distance is 10 m in the same room.
1. First use the test tone to check which speaker is playing the
wrong channel. Reconnect this speaker as described in WSP
(Wireless Speaker Pairing) and select the correct channel.
English
3 1 19