Canton Smart Soundbar 10 Bedienungsanleitung Seite 116

English
Problem
The Soundbar 10 does
not turn on automati-
cally.
Soundbar 10 switches
off automatically.
Soundbar 10 does not
turn off automatically.
116
Possible cause
1. The standby function is factory set to NSB. The
system must be turned on manually.
2. The device has been switched off via the
"ON / Standby" button of the remote control
or the "Power" button of the TV remote
control (when using the IR learning function).
3. The signal at AUX (Line) input is too low.
1. The standby function ECO, AUT or NSB is activa-
ted.
2. The infrared command for Standby has been
learned incorrectly.
1. The standby function MAN is activated.
2. The standby function AUT or NSB is activated
and the source device also transmits a carrier
signal in standby mode (optical or coaxial digital
input, only).
Solution
1. Switch the standby function to AUT.
2.1. Switch on the Soundbar 10 via the "ON / Standby" button of
the remote control and wait until it automatically switches
to the standby mode, next time.
2.2. Delete the "Power" button of your TV remote from the
Soundbar 10 to prevent it from switching off together with
your TV.
3. Increase the output level on your source device.
1. Select the standby function MAN.
2. Learn the infrared command for Standby again.
1. Activate the standby function ECO, AUT or NSB.
2. Disconnect the source device from the mains or
manually switch off the Soundbar 10.