Speaker Distance [Dst] - Canton Smart Soundbar 10 Bedienungsanleitung

English
Use the "+" resp. the "–" button to change the volume level. Go back to the speaker selection list by pressing the "OK" button.
7
In addition to the front left [FL] speaker you can adjust the virtual center [VCE] speaker, the front right [FR] speaker, the virtual surround right
8
[VSR] and surround left [VSL] speaker, the two speakers Top Left [TL] and Top Right [TR], as well as the subwoofer [SUB].
You can find additional information in the description in the "Sub output" and "Wireless speaker pairing" part.
The speaker selected in the list of speakers by using the
9
have approximately the same volume level. It is difficult to find the correct volume level for a subwoofer, because of the different frequency
band. Therefore, adjust the Subwoofer value to your preferred level.
To exit the menu item, press the "M" button. The test tone generator will be deactivated automatically.
10
Note: Speakers marked as "Virtual" are physically not available. The corresponding channel is generated by the physically available speakers and
therefore the gain is only "virtually" adjusted.

Speaker Distance [DST]

An adjustment of the distance between the speakers and listening position is needed for a perfect spatial effect, especially in case of multichannel
input signals. Measure and enter the distance between the speakers and your listening position. The distance is adjustable between 0.0m and 9.9m,
in steps of 0.1m, where 3.0m is the factory setting.
To adjust the distance please do as follows:
To enter the menu, press the "M" button.
1
Enter the first menu item Speaker Setup [SPS] and press the "OK" button.
2
Enter the menu item Distance [DST] using the
3
Select the speaker that you want to adjust the distance of by using the
4
All deactivated speakers are greyed out and cannot be adjusted.
You can find additional information in the description in the "Sub output" and "Wireless speaker pairing" part.
You can adjust the distance by using the "+" and "–" buttons. To go back to the speaker list press the "OK" button.
5
Press the "M" button to exit this menu item.
6
Note: If the distance is bigger than 9,9m, set the difference values of the individual distances in relation to 3m. Decisive for the calculation of the
spatial effect are the differences between the channels, not the absolute distance values.
88
" " or " " button plays back the test tone. At your listening position, all speakers should
" " or " " button and confirm with the "OK" button.
" " or " " button and press the "OK" button.