Input Config [Inp]; Input Name [Nam] - Canton Smart Soundbar 10 Bedienungsanleitung

English
Notes: • If the standby mode is set to Auto [AUT] and the Soundbar is set to standby mode using the "ON/Standby" key of the remote control, it
is not possible for the Soundbar to switch on automatically. To use the Auto mode of the Soundbar as intended, do not power down the
Soundbar using the On/Standby key but always wait until the Soundbar powers down, automatically.
• To avoid an unintentional power-up of the Soundbar using the analog input, the threshold value has been set quite high. To make sure the
Soundbar 10 powers up correctly, please set the output level of your analog audio source to a high level (but not more than 2Vrms).
To set the standby mode, please do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Choose the function Standby Mode [STB] using the
3
Use the "+" or "–" button to select the wanted Standby mode and confirm with the "OK" button.
4
Press the "M" button to exit this menu item.
5

Input Config [INP]

The menu input config contains the two submenus Input Name [NAM] and Analog Offset [OFS].

Input Name [NAM]

With the default factory setting all physically available inputs are already assigned with a source designation. Therefore, the device display
and the screen do not show the designation of the (physical) input, but the designation of a (possible) source device (e.g. [BDP]). These are as
follows:
Physical input
HDMI Input 1
®
HDMI Input 2
®
HDMI Input 3
®
HDMI Output
®
Optical digital input
Coax digital input
Analog line input L/R
You can change the default assigned name of an input to suit your actual connected source device. It is also possible to deactivate (physical)
inputs so that they are no longer displayed when switching through, which allows a faster selection of the input. The name for the input BT
(Bluetooth ) or NET (Network) can not be changed.
®
98
" " or " " button and confirm with the "OK" button.
OSD Display Name
HDMI1 [HD1] = BDP
HDMI2 [HD2] = SAT
HDMI3 [HD3] = PS
ARC [ARC] = TV
OPT [OPT] = CD
COAX [COA] = DVD (DVD player)
Analog [LIN] = AUX (Analog device)
(Blu-ray player)
(Satelite receiver)
(Gaming console)
(TV)
(CD player)