Analog Gain [Ofs]; Input Select [Sel] - Canton Smart Soundbar 10 Bedienungsanleitung

To change the name and/or deactivate the input proceed as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Select the item Input Config [INP] using the
3
Confirm the first menu item Input Name [NAM] by pressing the "OK" button.
4
Then select the wanted inputy with the
5
You can choose from the following predefined designations using the "+" or "–" button:
" – – – " (input disabled), TV, BDB, SAT, CD, DVD, CAM, REC, PAD, POD, TAB, TUN, DAB, PS, VCR, ATV, PC, AUX.
After selecting the name, press the "OK" button. .
To assign a name to another input, repeat steps 4 to 6.
6
To leave this menu item, press the "M" button.
7
Notes: • Should you assign a name to an input that is already assigned, the input previously assigned with this name will be deactivated (" – – – ").
To continue using this input, you must assign a different name. Each source name can be assigned only once.
• Inputs which have been deactivated " – – – " are no longer displayed when selecting the inputs (input buttons
This simplifies the selection of the desired input.

Analog Gain [OFS]

With this function you can adjust the signal gain of the Line input [AUX] between -6dB and +6dB in steps of 1dB to match the level of the digital
inputs. This allows you to (partially) equalize the different signal levels of analog sources. 6dB allows you to half (-6dB) resp. double (+6dB) the
volume level of your analog source.
For setting the offset volume level of the Line input, proceed as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to select the menu item Input Config [INP] and confirm by pressing the "OK" button.
3
Select the menu item Analog Gain [OFS] and confirm with the "OK" button.
4
Select the wanted level using the "+" or "–" button to match your analog device and confirm with the "OK" button.
5
To leave this menu item, press the "M" button.
6

Input Select [SEL]

If the Input Select function is set to Auto [AUT], the Soundbar 10 automatically changes to the optical, coaxial, analog resp. BT input as soon as the
signal disappears at the currently selected signal input and an input signal is detected at one of the other inputs of the Soundbar.
" " or " " button and confirm with the "OK" button.
" " or " " button and press the "OK" button.
English
" " or " ").
3 9 9